Danish System 34 (1999) Projection

(1999 variation, using order 13 polynomial)

This projection is a variation of the Transverse Mercator projection used in Denmark. The projection consists of a base UTM (zones 32 & 33) calculation, which is then adjusted by an order 11 polynomial, and then further adjusted by an order 13 polynomial.

Note that a previous version of this projection was used up until 1999, based solely on the order 11 polynomial. This newer version is a further refinement of those results using the additional order 13 polynomial.

The polynomials used in the Danish System 34 projection were developed by K. Poder and K. Engsager of Kort & Matrikelstyrelsen. The polynomial coefficients can be obtained by contacting Kort & Matrikelstyrelsen.

The "DanishSystem34_99" Projection has the following Parameters:

Parameter Name	Parameter String	Units
Region	region	String

Region is used to indicate which part of Denmark the projection is being applied to. The valid region values are as follows:

Region	Parameter Value
Jylland	“j”, “J”, or “1”
Sjælland	“s”, “S”, or “2”
Bornholm	“b”, “B”, or “3”
National	“u”, “U”, or “4”